Skip to Content

Adjusting the air chamber height (installing the fork springs)

Adjusting the air chamber height

Precise adjustment of the fork oil level
For precise adjustment we recommend our fork oil level adjustment set! Universal for all motorcycles!
Any quality fork oil can be used as the new fork oil. Because WIRTH fork springs are usually set up somewhat firmer, we generally recommend choosing a viscosity grade one higher than the original, e.g. SAE 15 instead of the original SAE 10. The higher viscosity is somewhat thicker and increases the damping.
    1. After removing the original fork springs, drain the old oil, flush briefly with fresh oil and let it drip off. Then fill the fork legs with the original oil quantity recommended by the vehicle manufacturer. (If only the “air chamber height” is specified, the stanchion and slider tubes must be pushed completely together, then fill with oil until the distance in “mm” between the oil level and the top edge of the stanchion tube corresponds to the specified air chamber.) The fork oil level adjustment set is extremely helpful here!
    2. Now reinsert the original fork springs (slider and stanchion tubes pulled apart again) and use a rod or similar to measure the height of the oil level to the top edge of the stanchion tube.
    3. Now pull the original fork springs out for good and insert the WIRTH springs, with the tight coils facing up. Measure the oil level again as before and level it to the same height as with the original fork springs. As a rule somewhat less oil is needed, because our springs are usually stronger in material and have more coils.

RESULT:

    The air chamber height is now set exactly as with the original springs, so the air cushion can contribute to the springing through compression – especially in the last part of the spring travel – just as the manufacturer intended.
Database neutralized for testing: no emails sent, etc.